First you need to make a printed circuit board. If you have it all, you can start assembling. Connector for connecting the programmer.Several capacitors and resistor (Looking at the diagram).A small piece of textolite - 50 x 80 mm.Therefore, when assembling my second metal detector -, after all, made a board for connecting microcontrollers to the programmer. As practice has shown, the mounted installation is not very suitable here - it is not very reliable. To flash the chip, it was necessary to raise quartz with two capacitors and it was not quite comfortable, but I was lazy to make a printed circuit board - and in vain. The first thing that comes to mind is simply to sue the wires to the controller panel and the programmer connector. I also encountered this problem when I decided to collect my first device on MK - Metal detector Tracker PI-2. If you collected something on the microcontroller, then surely faced the problem of connecting the chip to the programmer. Hello everyone! In this article I will tell you how to collect a simple adapter for connecting AVR microcontrollers to the programmer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |